After you draw your parts, What then?

  All parts must be laid-out on rectangles that represent the raw balsa or plywood material that the parts will be cut from. Below are examples of this. Remember... our table cannot accept anything over a 12"x 24" sheet of material. Parts longer than this can be "finger jointed" to get the length you need. Balsa sheets in the 3"x 24" or 4"x 24" ,etc, are okay. Sheets can be less than 24" long.

  This would constitute a typical LASER file. ALL of the parts for one kit can be on one file, but they must be separated into their respective size materials. The size of the sheets should be noted as well as the quantities of each sheet to be cut. Also, your name, the name of the plane, and the date of the file should be in the lower left hand corner. This will help us keep track of your job.

  All cut lines by the LASER should be RED. If you would like your part numbers etched on your parts, these must be GREEN.

  If we have to go into your file to arrange parts on the material sheets there will be a $30.00 per hr. charge to do the work. If you have any questions, E-mail us or give us a call.

(803) 499-5487